You can find more details on the available pins and labels in the PeripheralPins.c and PinNames.h files. Mass storage (USB Disk drive) for drag'n'drop programming.USB re-enumeration capability: three different interfaces supported on USB.USB VBUS or external source (3.3 V, 5 V, 7 - 12 V).Selection-mode switch to use the kit as a standalone ST-LINK/V2-1.On-board ST-LINK/V2-1 debugger/programmer with SWD connector.STMicroelectronics Morpho extension pin headers for full access to all STM32 I/Os.16-stream DMA controller with FIFOs and burst support.GPIOs (114) with external interrupt capability.256+4 KB SRAM, including 64 KB of CCM (core couple memory) data RAM.The STM32 Nucleo-144 board does not require any separate probe, as it integrates the ST-LINK/V2-1 debugger/programmer and it comes with the STM32 comprehensive software HAL library, together with various packaged software examples,, as well as a direct access to the ARM®mbed™online resources. The ST Zio connector, which is an extension of Arduino™ Uno V3, provides access to more peripherals and ST morpho headers make it easy to expand the functionality of the Nucleo open development platform with a wide choice of specialized shields. Connect your Nucleo board to your PC.The STM32 Nucleo-144 board provides an affordable and flexible way for users to try out new concepts and build prototypes with the STM32 microcontroller, choosing from the various combinations of performance, power consumption and features.Open the STM32 Nucleo driver and install it.Save and unzip the file to a local directory.Go to the Nucleo Firmware page and scroll down to the bottom of the page and select the link First install the ST-Link driver.To check and upgrade the firmware version, you can follow the instructions below. In order for the STM32F411RE Nucleo board to be ready for programming with the mbed development environment, it is required to run the STLinkV2-1 firmware version V2.J22.M5 or later. The STM32F411 Nucleo board allows developers to try out new ideas and quickly create prototypes with the STM32F411 MCU. This will take you to the platform page with all information on how to get started with mbed. At the top of the mbed webpage, select the "Platforms" button and then select ST Nucleo F411RE platform.If you have a login and password, login to your mbed account or click the "Signup" button to create an account.Click the "Login" or "Signup" button on the home page.Mass storage (USB Disk drive) for drag'n'drop programmingīefore plugging your Nucleo board into your PC, first complete the following steps: ¶.Virtual Com port to send back traces to the PC.Debug and programming port, to use STM32 Nucleo with standard toolchains/debuggers/programmers.On-board ST-LINK/V2.1 interfacing with the PC, with three different communication channels via USB.Flexible board power supply: USB VBUS or external source (3.5 V, 5 V, 7 V - 12 V).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |